-
1
"Officer, I swear it's not stolen!"
-
Advertisement
-
2
Find an old screw driver with a shaft about the same width as your key. Cut the shaft, leaving about an inch.
-
3
Cut a 1/4" to 3/8" slot in the shaft.
-
4
Round the end with a grinder or file.
-
Advertisement
-
5
This creates a smooth transition from the screwdriver to the key.
-
6
Trim a spare key, making sure it's long enough to fit in the ignition on one end, and the screwdriver slot on the other.
-
7
Make the end wider or narrower so that it fits in the screwdriver slot.
-
Advertisement
-
8
Put some flux on the end of the key and tap it into the slot. Solder with torch.
-
9
Use a grinder and sandpaper to line-up and smooth-out your connections.
-
10
Now you're ready to cause suspicion as you drive around town!
Scroll down for the next article