Favorite

Drive it Like You Stole It

Make your own screwdriver-key and feel like a thieving badass, like from the movies!

Share
Tweet
Stumble
Pin It
Email
  • 1

    "Officer, I swear it's not stolen!"

    Via: hahabird

  • 2

    Find an old screw driver with a shaft about the same width as your key. Cut the shaft, leaving about an inch.

    Via: hahabird

  • 3

    Cut a 1/4" to 3/8" slot in the shaft.

    Via: hahabird

  • 4

    Round the end with a grinder or file.

    Via: hahabird

  • 5

    This creates a smooth transition from the screwdriver to the key.

    Via: hahabird

  • 6

    Trim a spare key, making sure it's long enough to fit in the ignition on one end, and the screwdriver slot on the other.

    Via: hahabird

  • 7

    Make the end wider or narrower so that it fits in the screwdriver slot.

    Via: hahabird

  • 8

    Put some flux on the end of the key and tap it into the slot. Solder with torch.

    Via: hahabird

  • 9

    Use a grinder and sandpaper to line-up and smooth-out your connections.

    Via: hahabird

  • 10

    Now you're ready to cause suspicion as you drive around town!

  • -
  • Vote
  • -
Share
Tweet
Stumble
Pin It
Email

Next on There, I Fixed It

My Little Soldering Iron
Comments